Univex SRMF20 Especificaciones descargar pdf (Pagina 7)

NOTE: Always return to speed “1” before shutting the mixer off. Do not move the speed control lever

when the mixer is not running, because this will cause the belt to become loose and the mixer will not

operate properly.

If the mixer has been shut off by the timer, or the stop button in speed 2, 3 or 4, follow these steps to

avoid belt slippage or jerky start: Empty the bowl. Set the timer to “HOLD”. Press the start button and

as the mixer begins to operate, move the speed control lever back to speed “1”. Press the stop button and

return the timer to “0”. Your mixer is now ready for use.

USING THE INGREDIENTS CHUTE

The ingredients chute provided with your mixer enables you to add ingredients to the bowl while the

mixer is running and without opening the Swing Ring™ Safety Guard. The chute may be installed on

the front or side of either half of the guard. Once the chute is properly installed, it can remain in place

permanently, if desired.

INGREDIENTS CHUTE INSTALLATION

Slide the bottom of the chute between horizontal safety guard rings and engage the chute onto the safety

guard.

USING A SMALLER BOWL

For maximum flexibility, a 12 quart bowl is available for use on the SRM20/SRMF20 mixer. Specially

sized agitators must be used. See page 9 for part numbers for these parts.

SPLASH / EXTENSION RING

A splash/extension ring (Page 9 [H]) mounted to the bowl helps confine ingredients during the mixing

of certain recipes. Never use the ring to overload the bowl. Consult the Table of Mixing capacities on

pages 8 for appropriate loads.

NOTE: Overloading the mixer beyond the factory specifications can damage the mixer and will void

the warranty.

Page 6

1 2 3 4 5 6 7 8 9 10 11 12 ... 16 17

Sin comentarios

Univex SRMF20 Especificaciones Pagina 7